PRODUCTS

OTM2612 1G and 10G Packet Ethernet Module is a compact test solution for the installation and maintenance for Metro/Carrier Ethernet and IP services. It supplies a compact test solution for 1G and 10G packet Ethernet, include ITU-T Y.1564 standard for SLA and OAM test features.

This module is compatible with OTP6200v2 (OPWILL Intelligent Network Test Platform).

 

 

 


 
Highlights

10Gbit/s data stream in maximum;

RFC2544 test includes throughput, latency, frame loss, and back-to-back;

IEEE802.3ah, IEEE802.1ag, ITU-T Y.1731, and ITU-T G.8113.1 OAM test (Coming Soon);

Y.1564 test;

BERT and loopback test from layer 1 to layer 4 with or without VLAN and MPLS tags;

Generate up to 512 traffic flows with different MAC address, VLAN tags, MPLS, IP address, TCP/UDP, payload, and bandwidth;

Service disruption test;

IPV6.

Applications

RFC2544 Test: OTM2612 fully meets RFC2544 standard, supports Throughput; Latency; Frame loss; and Back-to- Back test in metro network, and can be able to generate a complete test report.

BERT Test: Ethernet BERT test adopts the similar principle of SDH BERT test. It is by transferring the Ethernet frames with special test code, then analyse these frames at the receiver to test the network.

Multi-Stream Test: OTM2612 supports to generate multiple data streams to test the forward ability of these service in Ethernet network. In addition, multiple data streams can be set as different priority.

 OAM Test (Coming Soon): OAM test supports IEEE 802.3ah, IEEE 802.1ag, ITU-T Y.1731, and ITU-T G.8113.1 OAM link and services protocol. It includes partner link detection, remote loopback, MIB retrieval, and link event notification. It also can check network connection, connection ring back; generate link trace messages, and analyse service level of OAM test application. ITU-T Y.1731 OAM message can practice frame loss performance verification. ITU-T G.8113.1 OAM message can verify the PTN network, and practice and the frame loss performance verification.

Y.1564 Test: RFC2544 was the most popular standard for Ethernet test. However, it is specially designed for indoor network facilities test, not suitable for outdoor field test. Hence, ITU‐T Y.1564sam is particularly introduced for telecom operator to do Ethernet network service launch and fault diagnosis. Compared with RFC2544, it includes critical SLA standards such as packet jitter identification and QoS measurements, which could increase test speed promptly, save test time and resource, and optimises QoS.

 

Key Features

Dual 10G Base-X test interfaces; Perform throughput, latency, frame loss, and back-to-back measurements per industry- standard RFC2544;

Dual 10/100/1000M Base-T and 100/1000M Base-X dual media test interfaces; Generate up to 512 traffic flows with different MAC address, VLAN tags, MPLS, IP address, TCP/UDP, payload, and bandwidth;

Network configuration testing and performance testing per standard ITU-T Y.1564; IEEE802.3ah, IEEE802.1ag, ITU-T Y.1731, and ITU-T G.8113.1 OAM support (Coming Soon);

RFC2544 and Y.1564 Bidirectional testing; Ethernet BER and loopback testing at layer 1, layer 2, layer 3, and layer 4;

Traffic scan according with MAC, IP, VLAN, MPLS label, and so on; MAC and VLAN flooding;

IPv4 and IPv6 traffic generation; Smart loop mode for layer 1, layer 2, layer 3, and layer 4.

Service disruption test;

 

Copyright © OPWILL Technologies Co.,Ltd. All Rights Reserved.